I have an ML350 G6 with a P410I controller. It has the backup battery installed.
It has 8 ports and 2 arrays configured on 7 disks
RAID5 SAS ARRAY A disk 1:1, 1:2, 1:3, 1:4, 1:5 - disk 1:4 failed.
RAID1 SATA ARRAY B disk 1:7, 1:8 - good
When disk I:4 failed, I replaced it, but the array did not rebuild. It says it is in Interim REcovery Mode. I am not having trouble accessing the logical disk from the OS (WIN2k8 R2), but I would like to have the fault tolerance back in place.
I have tried 2 new replacement drives, but neither work. I can see them if I plug them into slot I:6, but not when I plug them into I:4. I:4 continuously reads failed in HPACU There is nothing I can seem to do.
I have tried removing the drive in the acucli, but keep receiving the message that the operation is not suported by the configuration.
I have updated to latest drivers, and firmware - to no avail
Please advise.