Re: DL380 G7 with p410i controller using RAID 5 question
I've just purchased the battery ($130) and installed in on my P410/512 controller. I have an existing 4-disk RAID5 and wish to expand to an 8-disk (All same model HDDs) but when I try add the spare...
View ArticleRe: DL360 G5 P400i BBWC Battery Died?
Skotte, Tonight after I am off duty, I go to the shop ask for exchange the Controller already. But look like he give me a real old board. The bad one (LSI *) Logo, the exchange one P400i is LSI LOGIC...
View ArticleML350e G8 LFF drive cage problem
Hi, I have a performance model ML350 with 6LFF drives & wish to install a 2nd drive cage (p/n 659485-b21) but have nowhere on the system board to plug the (included) 8pin pow connector Please help,...
View ArticleRe: ML350E GEN8 Drive Bay Power
I believe that I have found the solution. I think that you need to upgrade to a RPS solution with the RPS enabler kit (under power in quickspecs) also you'll need a 460W common RPS too Don't quote me...
View ArticleRe: Installing Win Server 2012 on ML110 G7 with RAID
I had exactly the same problem. It turned out that the Windows Server 2012 media disc was bad. I downloaded the ISO again, I prepared a USB and it worked!
View ArticleHP SAS 2TB drives flash amber and then clears
I am new to the HP Proliant server line, so please forgive me if there is an obvious answer to this question.... I have a DL380 G8 with Smart Array P421 and three Storageworks enclosures attached with...
View ArticleConfiguring HP Event Notifier on DL380p Gen 8 Running Windows Server 2012
I am deploying a few Windows Server 2012 servers on HP Proliant DL380p Gen 8 server hardware. In the past it was pretty simple to configure the HP Event Notifier to send us email alerts on faulty...
View ArticleRe: Configuring HP Event Notifier on DL380p Gen 8 Running Windows Server 2012
I was able to get the test traps to work by running the HP Management Agents fuction in Control Panel as Administrator. It seems even if UAC is disabled in Server 2012, you need to run the Evnet...
View ArticleRe: Configuring HP Event Notifier on DL380p Gen 8 Running Windows Server 2012
If you want monitoring, you should take a look at HP Insight Remote Support 7.0.5. You can monitor all your servers from a single application, the application will open a case at HP if needed and you...
View ArticleRe: GeForce GTX Titan running PCIe 2.0 instead of PCIe 3.0 on ML350p Gen 8
Thank you for the suggestions. We tried the card in slots 6 and 8 as well, but it still runs in PCIe 2.0 mode. For the graphics cable, the Titan has the same power connectors as the Quadro 6000...
View ArticleRe: Updating the ILO Firmware
I have another issue too...DL380s running iLO firmware 1.78. Tried to update to 2.15 bit it doesnt seem to do it. Do I need to update to older versions first?????
View ArticleRe: Updating the ILO Firmware
Which generation of DL380? The oldest generations (up to G4) may have the original iLO, for which the last released firmware version is 1.94. The next version is iLO2, for which the firmware 2.15 is...
View ArticleRe: HP ML350e Gen8 Fan Noise
Hi all, Upgrading the storage controller firmware to version 3.54 fixed this problem for me. One thing to note is that after installing the firmware, I needed to reset the iLO before it took effect. I...
View ArticleRe: HP Proliant DL 360 G7 stuck during POST ?
May I know how and where to look at that ? FYI: this server has no iLO setup yet.
View ArticleProLiant DL140 Fan Control and BMC
Hi! I'm hoping someone who has expierence with the ProLiant DL140 G1 Servers can help me out. I recently aquired a bunch of these servers for dirt cheap, so they were a bit hard to pass up.Now, I...
View ArticleRe: HP Proliant DL 360 G7 stuck during POST ?
Plug a DHCP network connection into the iLO port, hopefully you have a way to look at your DHCP server to see what IP address was assigned to the iLO (pointers to a couple of user create programs to...
View ArticleRe: ask - Recommended Configuration for Domain Controll and SQL Server
hi, sorry. is there reference model to meet my needs? I prefer for tower model. thanks.
View ArticleRe: HP Proliant DL 360 G7 stuck during POST ?
For such cases I have a small DHCP server installed on a laptop with a single IP address to assign. Connected to the ilo port using a cross cable. So you can be sure what address the ILO got.
View ArticleRe: HP SAS 2TB drives flash amber and then clears
Hi, In rare cases there could be some firmware issues with the drives. You may refer to this doc for drive led details:SAS or SATA Hard Disk Drive LED Combination.Gen8 SmartDrive LED Combination....
View ArticleRe: ML350e G8 LFF drive cage problem
Hi, The part in question is 659485-B21 HP 5U 6 Large Form Factor (LFF) Hot Plug Drive Cage Kit. Refer to the HP ProLiant ML350e Generation 8 (Gen8) QuickSpec.HP ML350e Gen8 Large Form Factor (LFF) 5/6...
View Article