Re: Launching Gen9 Insight Diagnostics from Command Line
Insight diags are included with the SPP. You can PXE boot the SPP and run from there, but not sure that really gains you anything over pressing F10
View ArticleRe: Network connection for new blade install
You need to configure virtual connect first and assign a profile to your server / server bay.
View ArticleRe: Driver needed for my HP Proliant ML350 Gen9 server
Hi, I have the same problem with the same server (HP Proliant ML350 Gen9 server) and Windows 2008 R2 but I can't find the correct...
View ArticleRe: Network connection for new blade install
VC is configured, a profile has been applied. I can see the FlexibleLOM NIC cards and assign them IP addresses. I just configured the NICs as Multi and now I can see 8 NICs. I assigned a couple of them...
View ArticleHp Proliant DL380P Additional HardDrive Install
Hello All-I have a question to ask. I have 2 HP Proliant DL380p Gen8 server and I just bought some additional 300GB hp hard drive to add to the existing 500GB . I've already added the new drive to the...
View ArticleRe: Network connection for new blade install
what is the oa firmeare page showing you? try a single ip address for the blade first.
View ArticleRe: Hp Proliant DL380P Additional HardDrive Install
you need to run the smart storage administrator
View ArticleRe: Driver needed for my HP Proliant ML350 Gen9 server
running SPP 2016.10 will install all needed drivers.
View ArticleRe: Hp Proliant DL380P Additional HardDrive Install
i am in the smart storage administrator now how do i add those drive
View ArticleRe: Hp Proliant DL380P Additional HardDrive Install
create a new array or extend array b.
View ArticleRe: Network connection for new blade install
OA Firmware is 4.40, VC Firmware is 3.17.I've since gone back to non-NPar, where I only have the 2 FlexibleLOM Ports 1 and 2. Only one has an IP address. I'm sure I'm missing something very simple here.
View ArticleRe: Network connection for new blade install
what generation is your server? version 3.17 may be too old.
View ArticleiLO2 Active Directory
Has anyone managed to successfully link iLO2 login to Active Directory? I've been playing around with it for some time to try to get all users in one container to have access without any success.
View ArticleRe: Missing Visio Stencil
Greg over at vsdfx.com (visiocafe) came to my rescue. Apparently HP never put out visio stencils for some servers a while back because they thought nobody would want them. Anyway Greg found some...
View ArticleHP Product Lifecycle
Hello, can anyone provide me the lifecycle information for the following HP servers:1) HP DL380 G72)HP DL360 G7I basically need to know when the product entered the market and how long will it be...
View ArticleUEFI slow boot SAS HBA - 336 drives
Hi Everyone, We have 336 drives connected to a single HP DL380 g9 server. The drives are connected via two PCIe cards - LSI SAS 9300-8e.Without the 336 drives connected the system boots up quickly...
View ArticleTemperature Sensor Names - DL360
Hello everyone. Could anybody give me a link to document which describes temperature sensors for DL360.Following sensors on my server have quite high temperature and a don't understand what they...
View ArticleiLO temperature sensors location
Hi,Is there any documentation with description about where are located temperature sensors (Front Ambient, VR P1, and so on) that are available from iLO?HP Proliant Gen9Br,Deniss
View Article