Hi, I currently have 2 groups of drives, each a RAID 1 setup, utilizing the B110i RAID controller. This controller has a 4 drive RAID maximum.
Ports 5 and 6 (3gbit ODD SATA ports) are not used, but I would like to utilise one of them for an additional (SSD) drive in non-RAID.
I am unable to achieve this. Each time I select SATA 5 or 6 to be a AUTO or ATAPI type, the setting is forgotten by the BIOS, probably because I have set the "SATA MODE SELECTION" to "RAID".
So, what am I doing wrong? Surely I am able to utilize the two remaining SATA ports, albeit not using the RAID controller? Thank you in advance!