AlertMail and o365
Hi,I've configured an o365 mailbox that has a valid license, I'm using this for all device emails since it's clean and neat.I'm hoping to configure iLO4 AlertMail with o365 but I don't see any options...
View ArticleArray controller P420i [Embedded] has reported that it previously locked up...
My server is down and need to cold boot.After server boot up and checked the system logs, an event message is shown:"Array controller P420i [Embedded] has reported that it previously locked up with...
View ArticleRe: VMware vSphere 6 On HP ProLant DL360 G7 Questions
Too general questions: SSD aren't bad or good, it's their usage that can be bad or good.SATA 6 disks should be recognized by the RAID/HBA Controller as SATA 6 is the RAID/HBA Controller is SATA 6...
View ArticleRe: HP Proliant ML310e wont start properly and make continuous beeps
Finally, yet again i'm sorry for the late reply. My brother finally got his hands on some new RAM yesterday and it's working now, after the replacement of the DIMMS the server would go through all...
View ArticleClik here to view.
Re: ML310e Gen8 V2 with Server 2016 Hyper-V
I refused to give up on this and I've stumbled on the following from HPE in this document: https://www.hpe.com/h20195/V2/getpdf.aspx/4AA5-5841ENW.pdfTable 5. Known issues and workarounds.Description...
View Articleupgrade from H240 to P440 retaining RAID
Hi,Is it possible to upgrade the controller in DL80 from H240 to P440/2GB FBWC retaining the RAID configuration and without data loss? If yes, how it could be done?Best regards,Natalia
View ArticleHP Agentless Management Service not starting (OpenSUSE Leap 42.1)
Hello Forum,i have a problem with my microserver gen8. I installed the HP SNMP Agents, HP Health and the HP Agentless Management Service. The Agents are running, but when i start HP AMS i get this...
View ArticleRe: ML310e Gen8 V2 with Server 2016 Hyper-V
Very happy to report that disabling VT-d has worked.Anyone else having the issue, remember you need to power the server off when changing VT settings in the BIOS or the don't take - a reboot is not...
View ArticleHPE System Management Homepage 7.6.0
Hello,I just start deploying HP System Management Homepage 7.6.0 and for the machines receiving 7.6.0 the shortcut previously used is broken.... (Previous version using this shortcut 7.5.5)URL:...
View ArticleUnidentified network status on ProLiant DL380 Gen9
Hi, I installed win2012 r2 in new server ProLiant DL380 Gen9. Two network cables are conected to HP Ethernet 1Gb 4-port 331i Adapter but network status is Unidentified.Should I try NIC teaming what...
View ArticleProliant ML110 - Additional drive in SATA 5 or 6
Hi, I currently have 2 groups of drives, each a RAID 1 setup, utilizing the B110i RAID controller. This controller has a 4 drive RAID maximum.Ports 5 and 6 (3gbit ODD SATA ports) are not used, but I...
View ArticleRe: ML110 G7 Main board LED status
ML110G7 support page:http://h20565.www2.hpe.com/portal/site/hpsc/public/psi/home/?sp4ts.oid=5075942Looked into this and it's a little frustrating. Troubleshooting guide mentions status LEDs and says to...
View ArticleRe: HP Agentless Management Service not starting (OpenSUSE Leap 42.1)
if you are using hp-ams-2.4.0 upgrade to hp-ams-2.5.0 (which was released last week on hpe.com). There was a known issue with some empty RPM tags that can result in the error you are...
View ArticleRe: Proliant DL360 G6 Hard Drive help!!
Drive Matrix:http://h20566.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c00305257
View ArticleRe: HP Agentless Management Service not starting (OpenSUSE Leap 42.1)
Hi Jimmy,so i removed the version before and installed the one you posted:rpm -ivh hp-ams-2.5.0-1969.32.sles12.x86_64.rpmwarning: hp-ams-2.5.0-1969.32.sles12.x86_64.rpm: Header V3 RSA/SHA1 Signature,...
View ArticleRe: Proliant ML110 - Additional drive in SATA 5 or 6
The Array Configuration Utility can identify the drive and sees "Unassigned Drives (1)". What if I set the "SATA MODE SELECTION" to "AHCI"? Will the two RAID arrays continue to function or is the RAID...
View ArticleProcedimento para cambiar HD SAS dañado en RAID 5 en Proliant DL360 G5
Buenos Dias Tengo un servidor HP Proliant DL360 G5 (MXQ816A11E) con una RAID 5 (Controladora Array P400i) y SO Windows Servder 2008, los discos son SAS de 146 GB 10 K colocados en las bahias 1,2 y 3...
View ArticleRe: Proliant ML110 - Additional drive in SATA 5 or 6
OK, so I bought a PCI-e card for 30 euro's. Spending money is less painful than working with HP.
View ArticleRe: HPE System Management Homepage 7.6.0
Hello,All HP services restarted.SNMP Service restartedsame issueIf I reinstalled SMH 7.5.5 it works fine again... so it is the version 7.6.0 which is changing something!!!Thanks,Dom
View ArticleRe: VMware vSphere 6 On HP ProLant DL360 G7 Questions
Thank you. The controller I have is the Smart Array P410i with 1gb of cache, it has 32 gb of ram and dual X5650 CPUs. I got 2 of them for $130 at a local auction and I sold the other one for $140 so I...
View Article