Server model (at least in my case) is a DL360 Gen 9. RIght now, it has a failed System board and is slated to be replaced tomorrow (second HP server--and we only ever had 2 to begin with) who had a major failure after placing it in service in less than 2 weeks after doing so), but that's a different matter.
If I go into the iLO Config menu, (which I did during my initial power-on event), I don't believe I purposefully expressed any domain, anywhere on any configuration--however, I do believe because it went out on its own and "discovered" the domain on which we sit, that it populated the domain name, and consequently is "present" when I get into the web version of iLO as described by the original poster--and won't let me save it "empty".
Assuming I can get into iLO Configuration (tomorrow when HP comes out to replace the System Board), what's to prevent the assigment of our domain again?
Thanks for your response.
Regards,
-mg