Re: Is an NC523 supported in a DL380 G5?
This is a duplicate, please reply in the following topic:http://h30499.www3.hp.com/t5/General/Need-to-install-10GbE-dual-port-card-into-DL380G5-NC522SFP-or/m-p/6463178
View ArticleRe: HP Proliant System Management E-mail notification
From Gen8 servers on, you don't really need the SMH and Insight agents anymore (you can go for Agentless Management Service). And definitely not for sending emails. You can do this now directly from...
View ArticleRe: HP USB Flash Utility Fails While Creating Intelligent Provisioning...
Problem was checksum of downloaded ISO was not correct. First clue should have been that a simple DOS command line copy of the ISO contents failed. Server IP upgrade from 1.3 to 1.6 not complaining...
View ArticleRe: ML350 g5 E200 controller failures on warm boot
HP ProLiant Servers - POST Error Messages and Beep Codes
View ArticleRe: ML350 g5 E200 controller failures on warm boot
Thanks, I'll keep that document. 1719 code recommends firmware update and replace the controller if it persists.Which I have done. What I'd really like to know is . Is there a diffence between how the...
View ArticleRe: ML350 g5 E200 controller failures on warm boot
I do notunderstand whatyou meant by"WarmBOOT" & "ColdBOOT"Bycons,the controllerneeds abatteryattachedto preservethe databeing transferredduring asuddenlypower cut.
View ArticleRe: ML350 g5 E200 controller failures on warm boot
By Warm boot I mean with out removing the AC power , restarting from windows or CTRL Alt Delete or even power cycle. Cold boot, removing the ac power cables so the server drains of power then...
View ArticleRe: ML350 g5 E200 controller failures on warm boot
For the Colld BOOT is equal to an "RESET ATX" you decharge all component but for tha warm BOOT all previous data are not cleared :), so if you need to do an Cold BOOT to restard server and the message...
View ArticleDL585 G2 compatible drives?
Hey i just got 2 DL585 G2 servers and i need some harddrives.Is it possible to use any harddrive as long as it's a 2.5" sas drive?Could somebody recommend me any drives? -Qube
View ArticleRe: DL585 G2 compatible drives?
Would a Toshiba "2.5 model: MBF2300RC 300GB SAS 10000RPM be a possibility?
View ArticleRe: DL585 G2 compatible drives?
Need information about controller card installed on this server
View ArticleRe: HP SUM "Failed to add baseline" No default baseline found.
I decided to testrun HP SUM 6.3.1 on my Notebook running Windows 7 Enterprise 64-bit.1. I copied “swpackages” from my bootable USB stick with SPP 2014.02.0 to C:\ , like in C:\swpackages2. I...
View ArticleCan't install Centos 5.10 x64 in a Proliant DL380e Gen8 Server
Gotthe followingquestion:When startingthe installation of Centos 5.10onmentioned server,does not detecttheSASdisks in the array. I have already installedthe license keyandI have...
View ArticleRe: DL585 G2 compatible drives?
Thanks for the quick answerThe controller which sits in my server is a smart array p400Was this any helpful information?
View ArticleRe: Intelligent Provisioning 1.60 Firmware Update Error Message
Same problem with 1.60b and ML310e G8 v2.After that: "Checking hardware, this may take a bit longer...." never finishes.
View ArticleML310e hot plug
hello,I am looking to buy the ml310e part number 724160-035 but not sure if it will take a hot plug hard drive?
View ArticleRe: DL585 G2 compatible drives?
Yes, it's helpful information :) You can check this list of supported HDD on this Controller Card http://h18004.www1.hp.com/products/quickspecs/12400_div/12400_div.pdf
View ArticleRe: Can't install Centos 5.10 x64 in a Proliant DL380e Gen8 Server
Wich type of controller card is installed on this server?
View Article