ACU doesn't detect SA controller on HP DL320 gen8 v2
Just received new HP DL320e Gen8 v2 E3-1220v3 (717170-421)I am trying to configure Smart Array controller. This server shipped with Smart Array B120i SATA. HDD: 2 x 500GB SC 6G 7.2K LFF SATA HotPlug...
View ArticleRe: ML 350p Gen8 P420i Raid controller performance problem with 3 x SSD in Raid5
I am not having good luck with the Intel DC S3500's right now. At this point, I am not sure where the issue is, but the just of it is, I have a DL360 Gen8 with E5-2620P420i disk controller4x300GB Intel...
View ArticleRe: DL320e Gen8 v2 fan noise
I found the answer without any help from HP. HP seem intent on sending a technician out to replace the motherboard and fan assemblies which now seems ludicrous. The issue appears to be caused by a bug...
View ArticleArray Controller
I have a ML350 G5 with E200i array Controller, I would like to upgrade my drives to 900GB SAS 2.5", would this controller work wioth these drives?
View ArticleRe: ML350 G5 Logical Drive 1 Consistency Check Failed Critical
Greetings.I need your help, please.Time ago, during usual maintenance (system management software) in a server (HP proLiant ML370 G6) I found some "strange" errors on some disks of the raid (5 + 1...
View ArticleRe: Looking for a small server that can minimize power consumption & heat
All the Gen8 products have a power capping feature that may assist you with your power requirements. Solid State drives may offer you better power savings as well. Let me know if you need power...
View ArticleRe: Missing Spare Management option in ACU
I have the same problem. Did any one solve it. May have to raise call with HP. See attachment.Thanks for any help, Ray
View ArticleRe: Missing Spare Management option in ACU
I tried also to do it aci cli with command ctrl slot=0 array A add spares=1:8 Got message reason "assignable spares not available" attaching diag report. We have 50 identical servers and only this one...
View ArticleRe: No ILO# SNMP Alerts
There is an update from Engineering via our HP support team. They were able to replicate the scenario in iLO2. “I just tested this using my iLO2 with PSP v9.70 and the latest 2013.02 SPP. The Agents...
View ArticleRe: Recovery for non-functioning iLO2 firmware fails
Hi,I have a similart issue:iLo2 1.50 corrupted during update (was stuck at 2% for 40 minutes and then I've decided to refresh the page) Set the security override switch to ON.Booted the server using...
View ArticleRe: HP ML350 G5 internal & external health leds blinking on front panel
I had the same issue. The array confoguration utlilty had an alert about the battery for the E200i controller card needing to be replaced. I have replaced the battery and am monitoring the server....
View ArticleDL360p Gen8 Intelligent Provisioning (F10) Illegal Opcode Red Screen
Hello everybody Having problems with a new DL360p Gen8 server. SO is not running and i'm trying to start Intelligent Provisioning (F10) to reinstall it.I just receive a red screen with Illegal Opcode...
View ArticleSmart DVD firmware update sometimes fails.
Hello.I have a HP Proliant DL580G5.I've downloaded the new smart update dvd from http://h20565.www2.hp.com/portal/site/hpsc/template.PAGE/public/kb/search/?sp4ts.oid=3454575&spf_p.t... I've...
View ArticleRe: DL360p Gen8 Intelligent Provisioning (F10) Illegal Opcode Red Screen
Does the error message appear before the HP splash screen is displayed or while it the HP splash screen being displayed. If it is before, then please note the four digit Status Code displayed at the...
View ArticleRe: Smart DVD firmware update sometimes fails.
It might be possible that the image downloaded was corrupted somehow or there may have been an issue with it while the disk was cut. There does not appear to be any issues documented about this so...
View ArticleRe: Smart DVD firmware update sometimes fails.
Whereas the servers run even though I turned off because the update procedure was freezed, do you think I can have some problems?
View ArticleRe: Smart DVD firmware update sometimes fails.
From what has been stated, there may not be an issue. It has been observed that firmware of key components have been updated indeed. Review the IML logs for any errors. If an issue is suspected, then...
View ArticleRe: Smart DVD firmware update sometimes fails.
Click here to select desired version of operating system. Then choose 'Smart Update Frimware DVD' listed under section 'Frimware – CD-ROM'.Can you tell me where is the section firmware cd rom? I didn't...
View Article