DL380p Gen 8 with E5 v2 Xeon availability -- when shipping?
Any info on when these will ship? I need to make some purchasing decisions.
View ArticleSA 6404 cache error
Hello, I have a HP proliant dl 385 with a SA 6404 on it, 256 mb cache, new batteries, and attached to it i have a HP MSA20 with 6 x 2TB disks . The thing is on the 6404 i get the following errors :...
View ArticleRe: What's the story wrt the new Smart Arrays -- P430/P430i/P431/P830 ?
I cannot see anything interesting about it , doesn't seem to be 12Gb/s:http://h18000.www1.hp.com/products/quickspecs/productbulletin.html#spectype=north_america&type=html&docid=14624
View ArticleHealth Light is On& DiMMs Light No: 8 is on. What is the problem?
HiWhat is the problem? When My HP Server DL380 G7:Health Light is On& DiMMs Light No: 8 is on& The server restarts some timesWhat should I do?I attached the Picture of Lights is Attachments...
View ArticleProliant ML110 G7 - Illegal OpCode Error
Hi. I have recently decided to rebuild my server and wanted to disable the hardware RAID so I could use software RAID in a Ubuntu installation. So I disabled the embedded B110i controller in the PCI...
View Articlebnx2: firmware not running aborting
Hello! After doing online firmware upgrades on a DL360G5 - remotelythe session hanged and were unable to reconnect (nor via ILO).The update of Broadcom NIC was not completed and the system was totally...
View ArticleML320e Gen8 v2, P222 controller not compatible with SATA?!
Hi.I have serious problem with Smart Array P222 Controller. I use Western Digital 1TB Velociraptor 10k drive WD1000CHTZ (http://www.wdc.com/en/products/products.aspx?id=20#tab3). When I cold boot...
View ArticleRe: DL160 G6 and P212, controller not detected
Looks like the built in sata backplane 570079-001 is not compatible/usable with P212. Found some information in this older...
View ArticleHelp with HP ACU and Linux CentOS
Hi, thanks for read this post. We have a ML110 G7, now we buy 4 disk for make a RAID 10 and install Centos 6.4 x64, but when i install my OS reboot and the machine say "trying to from C:" i disabled...
View ArticleRe: ML320e Gen8 v2, P222 controller not compatible with SATA?!
So when you cold boot the system without any disks connected to the controller, does the controller ROM show up during POST? The controller is PCIe 3.0 and supports 6GB SAS and 6GB SATA
View ArticleRe: ML320e Gen8 v2, P222 controller not compatible with SATA?!
On a related note, have you disabled the internal B120i Dynamic Smart Array? If not you need to either disable it, or make sure you set the P222 as the boot controller Is this a DL320e Gen8 v2? or n ML...
View ArticleRe: Proliant ML110 G7 - Illegal OpCode Error
Hi: There are two ways to clear system board NVRAW. One is to use of a maintenance swtich as you mentioned above,and the switch is located on the "2" position in the picture below. And the other way to...
View ArticleRe: Health Light is On& DiMMs Light No: 8 is on. What is the problem?
Hi, It means that DIMM 8 is either bad or not seated properly.Switch OFF the server and reseat the DIMM.Test the server if problem continues, replace/swap DIMM 8. If you have System Management...
View ArticleRe: HP dl320 380 g6/g7 hardware inventory
Hi, hpasmcli readme file. More documents available here and here. Thank You!I am a HP employee.
View ArticleRe: Help with HP ACU and Linux CentOS
Hi, ProLiant ML110 G7 has Embedded Smart Array B110i SATA RAID Controller (RAID 0/1/10). You disabled raid built in card, so which Raid card have you installed? Thank You!I am a HP employee.
View ArticleRe: Proliant ML110 G7 - Illegal OpCode Error
Hi Wanhao.Thanks for taking the time to highlight the specific parts on the schematic. That one of the smallest DIP switch arrays I have ever seen.NVRAM now reset and all is as it should be. Lesson...
View ArticleRe: HP ML350e Gen8 Fan Noise
I have a new ML350p, with all the latest updates, my fans hover around 35% non-stop. All my thermal settings indicate that they should be running lower. I have a non-HP expansion card installed as a...
View ArticleRe: ML320e Gen8 v2, P222 controller not compatible with SATA?!
>So when you cold boot the system without any disks connected to the controller, does the controller ROM show up >during POST? Yes, without disks controller shows up at POST. I've change disks to...
View ArticleRe: New 1Gb Broadcom Multifunction Win64 driver (7.8.6.0) is buggy
I can confirm I have have seen the exact same strange buggy behaviour with Broadcom 7.8.6.0 driver on 2012 Hyper-V. As with you rolling back to the previous driver resolved the issue.
View ArticleRe: HP Service Pack for ProLiant 2013.09.0 (B) - Download Issue
Hi Marco, Just go to the SPP download site at HP - hp.com/go/spp and hit the download button.... Regards, Steve.b.
View Article